You are halfway through a kitchen refit when the customer leans on the counter and asks, “While you are here, could you move that outlet too?” It takes twenty minutes and you say yes, because they are standing right there.
Three weeks later you sit down to write the final invoice. The quote says one thing, your notes say another, and you cannot remember what the outlet was worth. You send the original amount and tell yourself it evens out.
Free: the Job Profit and Fast Invoicing Checklist. One page to help you bill every job within a day and catch what never reaches the invoice. Get the checklist
What unrecorded extras cost you
The loss is quiet. Each favour is small, so nobody notices one. Added together, they turn a job that looked fine on the quote into one that earned less than you planned, and you only find out once it is finished.
Why extras slip through
Nobody is trying to get something for nothing. The request comes while you are busy, saying yes feels friendlier than stopping to write it down, and the invoice is prepared from the original quote instead of from what actually happened.
The process: four steps from “sure, no problem” to a paid extra
1. Name the extra out loud
When a new request comes in, say that it is outside the original quote and that you will confirm the price. It takes ten seconds and it is not rude.
Example: “That is a little beyond what we quoted. Let me work out the cost and send it over today.”
Pro tip: Say “extra” rather than “problem”. It keeps the tone friendly.
2. Write it down the same day
Note what was asked, who asked, the date, and an honest estimate of the time and materials involved.
Example: “Moved outlet, kitchen wall. Asked by the owner on Tuesday. About an hour and one box.”
Pro tip: Keep one notes page per job, so every extra lands in the same place.
Free: the Job Profit and Fast Invoicing Checklist. One page to help you bill every job within a day and catch what never reaches the invoice. Get the checklist
3. Get a yes in writing before you start
Send a short message with the extra and the price, and wait for a reply. A text or email that says yes is enough for most small jobs.
Example: “Outlet move, added to the job at the price above. Reply YES and I will book it in.”
Pro tip: If they say no, you lose nothing. That is better than finding out at invoice time.
4. Bill from your notes, not from the quote
When the job is done, build the invoice from the original quote plus every approved extra on your notes page.
Example: “Original quote plus the outlet move, shown as two lines.”
Pro tip: Look at the notes page before you open the invoice, not after.
Where this runs
All four steps work on paper or a spreadsheet. When volume grows, we run the same process in the business system we set up for clients (Odoo Community), where the quote, the added lines and the invoice stay connected. The process is the point. The tool just keeps it going when you are busy.
Your next step
This week, open your last finished job and compare the quote to what you billed. Write down any extra that did not make it onto the invoice, and start a notes page for your next job. The free checklist covers the same ground in one page.
Free: the Job Profit and Fast Invoicing Checklist. One page to help you bill every job within a day and catch what never reaches the invoice. Get the checklist